RADARTECH

Raspberry Pi configuration




This part explains how to configure the Raspberry Pi in order to be ready for software installation.

To have a proper configured OS, you have to go trough the following steps:
  -   Hardware setup
  -   OS setup

Please follow the below steps:

     

1.   Hardware setup



    1.1.   Insert the SD card into it's slot on Raspberry Pi.
    1.2.   Connect the HDMI cable between Raspberry and monitor.
    1.3.   Connect Raspbery Pi to the internet using the ethernet cable.
    1.4.   Connect the USB hub into one of the USB ports on Raspberry Pi. Connect your keyboard and mouse to the USB hub.
    1.5.   Connect Raspbery Pi to the power supply.

DO NOT CONNECT YOUR RECEIVER TO THE RASPERRY PI AT THIS STAGE!


    1.6.   Power on the device.



     

2.   OS setup



    2.1.   Once the OS is loaded, the below screen appears:

Fig016


On the Welcome dialog box, press "Next".

    2.2.   Set the country, language, and keyboard. Tick "Use the english language" and "Use US keyboard" and press "Next".

Fig017


    2.3.   Next step, set your password and press "Next".

Fig018


    2.4.   Once the motitor it will not be attached all the time to Raspberry Pi, here just press "Next".

Fig019


    2.5.   The device is connected to the internet via ethernet cable, so just press "Skip".

Fig020


    2.6.   On the Software Update dialog box, press "Next" and wait till the update is finnished.

Fig021


    2.7.   When the update is done, restart the device.

Fig022





  Powered by www.duduman.ro